Oper Way To Put Hinge On Door And Jamb

Lay the old door back on top of the new one and then transfer your hinge mortise lock set mortises and door hole outlines.

Oper way to put hinge on door and jamb.

However when hanging my own doors i like to put the three knuckle leaf on the door for the simple reason that it s easier to re hang the door. Because we haven t routed for the hinges yet and they are still attached to the jamb it should be a snug fit for the width. Double check to make sure that your outlines match the same location on the door and jamb before moving to the next step. Once the door is shimmed all the way up tight to the quarter check the reveal along the top and the sides.

Trace around the hinge. Score the outer edges. Use a combination square to lay out the mortises making sure that you re transferring the proper width and height of the outlines. Door hinges which way is up.

Screw the door frame together with 2 1 2 inch screws. From a mechanical point of view it doesn t make any difference and when installing factory assembled doors i keep the hinges however they are installed. The depth of the hinge on the jam should always be as thick as the hinge is. Step 2 insert a shim into the cutout.

Begin with the mortises on the door then the mortises on the jamb. I wasn t paying attention and forgot to note which part of the hinge goes back on the door and jamb. Cut shims to match the dimensions of the hinge cutouts. Using a mortising template route matching mortises for the hinges on the door and jamb.

Put your hinge in place on the door and the jamb and use a carpenters pencil to carefully trace around the hinge. Notes on door hinge placement hinge placement varies depending on whether your door is left swing or right swing in swing or out swing. Attach it using your hammer and a nail or two. I took all the doors off the hinges and the hinges off the jambs and doors in order to paint all the woodwork trim and doors in my house.

These notches or mortises should be just deep enough to. Attach hinges cut the head jamb to a length equal to the door width plus the combined rabbet or dado depth plus slightly more than 1 8 inch. Attach the hinges to the jamb and the door.